To run label calibration for an Arkscan label printer using the single button calibration method, follow these steps:
Load Labels: Place the labels with the sticker side up and about 1/2 inch of the label outside the printer.
Power Up Printer: Switch on the printer by pressing the power switch located at the back of the printer. The LED light will become solid blue.
Hold the Button: Press and hold the green button on top of the printer for about two seconds. Then, release the button immediately when the printer beeps or the light flashes red.
Verify Calibration: If done correctly, the printer should push out two blank labels, and the perforated line should align with the printer's edge.
A Detailed Instructions can be found in YouTube tutorial below: